Sealey TP50 - Manual

3.1 TO USE AS A SYPHON
3.1.1 Insert one end of each of the two orange, hoses into the black connectors (A), see fig.1.
3.1.2 Push the orange hoses right into the nozzles. Then ensure the black connectors (A) are pushed securely
over the nozzles.
3.1.3 Put the orange hose from the top nozzle (intake) into the liquid to be transferred. Then insert the orange
hose from the bottom nozzle (discharge) into where the liquid is to be discharged.
NOTE: For proper syphoning the discharge hose must be lower than the intake hose.
3.1.4 Pump the handle 3 or 4 times to prime it, once the liquid begins to flow, it will flow without further pumping.

WARNING! After syphoning petrol, oil or any other flammable liquid, it is very important to clean the
pump.
3.2 TO CHANGE OIL
3.2.1 Follow steps 3.1.1 & 3.1.2 above. Insert the dipstick tube into the black adapter (B) and insert the adapter
(and dipstick tube) into the end of the top (intake) orange hose. Insert the other end of the dipstick tube into
the engine’s dipstick hole and lower it in until it reaches the bottom of the oil sump. Place the bottom
(discharge) orange hose into a drain pan and begin pumping.
3.3 TO USE AS AN AIR PUMP
3.3.1 Place the air pressure hose into the bottom nozzle (discharge) and tighten securely, begin pumping. To
inflate pool toys, beach balls, etc place an inflation needle into the threaded adapter on the end of the air
pressure hose, then begin pumping.
4.1 Flushing the pump with water is usually all that is needed for cleaning. For more thorough cleaning the pump
can be disassembled, without the use of tools, and cleaned.
InsTrucTIons For:
MULTIPURPOSE SYPHON & PUMP KIT
MoDEL no :
TP50.v2
IMPorTAnT: PLEAsE rEAD THEsE InsTrucTIons cArEFuLLY. noTE THE sAFE oPErATIonAL rEQuIrEMEnTs,
WArnInGs & cAuTIons. usE THE ProDucT corrEcTLY AnD WITH cArE For THE PurPosE For WHIcH IT Is
InTEnDED. FAILurE To Do so MAY cAusE DAMAGE AnD/or PErsonAL InJurY AnD WILL InVALIDATE THE
WArrAnTY. PLEAsE KEEP InsTrucTIons sAFE For FuTurE usE.
 WARNING! DO NOT operate using flammable liquids in a confined space, the area should have adequate
ventilation.
3
If pumping flammable liquids, avoid proximity to naked flames or welding operations.
3
Wear appropriate protective clothing when pumping solvents. We recommend eye/face and hand protection,
available from your authorised sealey dealer.
3 Ensure Health & safety, local authority, and general workshop practice regulations are adhered to when
using this equipment.
3 Ensure spillages are dealt with immediately. Failure to do so could lead to personal injury or damage to the
environment and possible prosecution by the authorities.
3 Keep children away from areas where solvents are being used.
1. SAFETY INSTRUCTIONS
Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
4. MAINTENANCE
2. SPECIFICATION
3. OPERATION
Composite pump assembly suitable for the syphoning of fluids including diesel, petrol, oil, detergents and pesticides.
not suitable for use with aggressive detergents and solvents. supplied with 2 x 1300mm transfer hose and 1200mm
narrow bore hose for performing oil extraction through the dipstick tube. The pump may also be used on inflatables
such as footballs and tyres - a 400mm hose and various clip-on connectors are supplied for this purpose.
Model No: . . . . . . . . . . . . . . . . . . . . . . . . . . . TP50
Transfer Pump Hose (x2): . . . . . . . . . . . . . . 1300mm
Small Bore Extraction Hose: . . . . . . . . . . . . 1200mm
Air Pump Hose:. . . . . . . . . . . . . . . . . . . . . . . 400mm
Original Language Version © Jack sealey Limited TP50.V2 Issue: 1 - 13/06/13