Sscli.v2 (contents), Sscli.v2 (assembly) – Sealey SSCL3 User Manual
Page 2
4. SSCLI.V2 (CONTENTS)
Reference
Description
Quantity
A
Folding base frame with fitted wheels
1
B
Diagonal Brace
2
C
Horizontal brace
5
D
1m Guardrail end frame
2
E
Toeboard set (2 long side, 2 short end)
1
H
Trapdoor Platform
1
5. SSCLI.V2 (ASSEMBLY)
NOTE: The mobile scaffold tower may only be assembled, used
and dismantled by persons familiar with these Assembly and Use
Instructions.
5.1 Open folding base A and insert the locking pin in the centre of the
folding section. (See fig.)
5.2 Place diagonal B on one side on the first rung and on the 4th
rung on the other side. (See fig.) Make sure that the butterfly
locking part is completely rotated to hold the diagonal firmly in
position.
5.3 Place horizontal brace C on the first rung and lock in position.
(See fig.)
5.4 Attach a diagonal B onto the lower rung of one of the two-rung
guardrail end frames D. (See fig.) Position the first two-rung
guardrail end frames D (without the diagonal) on the base and
then put the two-rung guardrail end frames D already equipped
with the diagonal on the other side of the base. (Ensure that the
diagonal B is placed at an angle to the one already on the base).
(See fig.) Ensure that the butterfly locking part is completely
rotated to hold the diagonal firmly in position.
5.5 Once end frames D are in position, put the 4 locking pins in place
and attach the base of diagonal B on to the 5th rung of the base
frame A. (See fig.)
5.6 Place platform H on the 6th rung from the bottom. Lock the wind
lock firmly into position. (See fig.)
5.7 Climb through the trapdoor, sit on the edge and position the two
lower horizontal braces C on the 2nd rung from the top. Lock the
snaplocks firmly in position. (See fig.)
5.8 Remaining seated in the same position, put the other two rails C
into position on the top-most rungs. Lock the snaplocks firmly into
position. (See fig.)
5.9 Install the toeboards (See fig.)
5.10 Lock all wheels prior to using the scaffold.
Original Language Version
SSCL1.V2, SSCL3, SSCL4 - 1 - 17/09/10