Sealey GH80 - Manual

INSTRUCTIONS FOR:
HAND CRANKED HOSE REEL 80MTR
CAPACITY
MODEL: GH80.V2
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS, AND
CAUTIONS. USE THIS PRODUCT CORRECTLY, AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO
MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.
GH80.V2 - 1 - 30/01/07
1. SAFETY INSTRUCTIONS
! Familiarise yourself with the application and limitations of the hose reel, as well as the specific hazards.
" WARNING! Disconnect the hose reel from the water supply before changing accessories, servicing or performing any maintenance.
! Maintain the hose reel in good condition (use an authorised service agent).
! Replace or repair damaged parts. Use recommended parts only.
Unauthorised parts may be dangerous and will invalidate the warranty.
! Locate and fix the hose reel in a suitable working area. Do not position
the hose in direct sunlight, or in areas of extreme heat or cold.
Ensure there is adequate lighting.
" WARNING! Ensure maximum pressure is not exceeded.
! Keep extended hose away from heat, oil and sharp edges.
Check hose for wear before each use, and ensure all connections
are secure.
! Maintain correct balance and footing. Ensure the floor is not
slippery and wear non-slip shoes.
! Remove ill fitting clothing. Remove ties, watches, rings, and other
loose jewellery and contain and/or tie back long hair.
! Keep children and unauthorised persons away from the working area.
# DO NOT operate the hose reel if any parts are damaged or missing
as this may cause failure and/or personal injury.
# DO NOT exceed the rated capacity of the hose reel.
# DO NOT use the hose reel for any purpose other than that for which it is
designed.
# DO NOT yank the hose from the water supply.
# DO NOT operate the hose reel when you are tired or under the influence of
alcohol, drugs or intoxicating medication.
# DO NOT direct water from the water hose at yourself or others.
! When not in use ensure the water supply is turned off and tools
disconnected. Disconnect from the water supply and retract the hose.
Hose Capacity (not supplied): .80mtr x Ø13mm
Inlet/Outlet: . . . . . . . . . . . . . . .13mm(1/2")
Max Pressure: . . . . . . . . . . . . .300psi (20bar)
Weight (Excluding Hose): . . . .10kg
2. INTRODUCTION & SPECIFICATION
Heavy-duty steel open style construction with mounting bracket for fix-
ing to wall or floor. Suitable for industrial applications or areas where
longer length of hose is required. Will hold up to 80mtr (260ft) of
Ø13mm hose. Screw operated drum lock.
3. MOUNTING/ASSEMBLY
NOTE! Fit reel to wall before fitting hose to reel.
3.1
Fix the reel in an appropriate position ensuring that the wall and the mounting screws and plugs (not supplied) will adequately support
the weight of the reel and the tension of the hose as it is pulled from the reel.
3.2 Ensure that the hose reel is located so that the hose can be operated without causing unnecessary sideways force.
3.3 It is recommended that two people fit the reel to the chosen surface, one to support the weight and the second to secure the reel
using the bolt holes (Fig 1 ). Four sturdy masonry bolts are suitable for securing the hose reel, providing they give ample support
during the unreeling/reeling of the hose.
3.4 Attach the hose to the 13mm (1/2”) fitting (Fig 1) and wind it onto the reel taking care to guide the hose from one side of the reel to the
other to prevent bunching of the hose.
3.5 Attach the supply hose to the 13mm (1/2”) external fitting.
Fig 1
13mm HOSE OUTLET