Ultimate Speed KH 4256 - Manual (Page 53)

51
Handling and operation
KH 4256
GB
MT
Check the increasing air pressure on the air pressure indicator ♦ 3 . As soon
as the desired infl ation level has been reached, switch the appliance off
(function switch
2 in the position “0”).
Open the closing lever of the connection valve ♦ 5 and then pull the con-
nection valve (complete with the adapter valve bonnet 7 , if one has been
used) from the valve of the infl ated article.
Measure air-pressure
NOTICE
The appliance does not need a power supply to measure the air pressure ►
of an infl ated object.
Check to see if a valve adaptor attachment ♦ 7 is required for use on the
infl ated object.
Should this be the case: Press the appropriate adapter valve bonnet
7
into the opening of the connection valve 5 and then push the closing lever
down.
If you do not have to use an adapter valve bonnet ♦ 7 , ensure that the
closure of the connecting valve 5 is open. When open, the closing lever
must point to the rear.
Place the opened connection valve ♦ 5 on the valve of the object to be
infl ated and then press it down so that it is seated fi rmly.
Close the connection valve ♦ 5 , in that you push the closing lever down.
Ensure that the connection valve cannot loosen itself.
Read off the air pressure on the air pressure indicator ♦ 3 of the appliance.
Open the closing lever of the connection valve ♦ 5 and then pull the con-
nection valve (complete with the adapter valve bonnet 7 , if one has been
used) from the valve of the air-fi lled article.
Buch_53356_LB5 indb Abs3 51 09 02 2011 11 39 38 Uhr