Ultimate Speed KH 4256 - Manual (Page 52)

50
Handling and operation
KH 4256
GB
MT
Handling and operation
In this chapter you receive important information for the handling and operation of the
appliance.
Ensure that the appliance is switched off (the function switch 2 is at position “0”) and then
connect the cable to the cigarette lighter.
IMPORTANT
This appliance is not suitable for continuous operation. Continuous usage ►
for more than 30 minutes in infl ation operations (10 minutes for air pump
operations) can cause overheating and damage to the appliance. Switch
the appliance off after the specifi ed time and take it back into operation
again ONLY when the motor has cooled down.
Infl ation operation
Remove the valve cap of the article to be infl ated. ♦
Fit the appropriate valve adapter attachment ♦ 6 on the air outlet opening
of the appliance.
Insert the valve adapter bonnet ♦ 6 into the valve of the article to be infl ated.
Switch the appliance on, in that the function switch ♦ 2 is placed in the posi-
tion “II”.
When the desired infl ation level has been reached, switch the appliance off ♦
(function switch 2 to the position “0”) and then remove the valve adapter
attachment 6 from the infl ated article.
Replace the valve cap back onto the infl ated article. ♦
Air pump operation
Check to see if a valve adaptor attachment ♦ 7 is required for use on the
object to be infl ated.
Should this be the case: Press the appropriate adapter valve bonnet
7
into the opening of the connection valve 5 and then push the closing lever
down.
If you do not have to use an adapter valve bonnet ♦ 7 , ensure that the
closure of the connecting valve 5 is open. When open, the closing lever
must point to the rear.
Place the opened connection valve ♦ 5 on the valve of the object whose air
pressure is to be measured and then press it down so that it is seated fi rmly.
Close the connection valve ♦ 5 in that you push the closing lever down.
Ensure that the connection valve cannot loosen itself.
Switch the appliance on, in that the function switch ♦ 2 is placed in the
position “I”.
Buch_53356_LB5 indb Abs3 50 09 02 2011 11 39 38 Uhr