Epson S5U1C63000A - Manual (Page 177)

CHAPTER 8: DEBUGGER
S5U1C63000A MANUAL EPSON 163
(S1C63 FAMILY ASSEMBLER PACKAGE)
pm
(program memory move)
Function
This command copies the content of a specified program memory area to another area.
Format
(1) >pm
↵
(direct input mode)
(2) >pm
↵
(guidance mode)
Start address ?
↵
End address ?
↵
Destination address ?
↵
>
: Start address of source area to be copied from; hexadecimal or symbol (IEEE-695 format only)
: End address of source area to be copied from; hexadecimal or symbol (IEEE-695 format only)
: Address of destination area to be copied to; hexadecimal or symbol (IEEE-695 format only)
Condition:
0
≤
address1
≤
address2
≤
last program memory address
0
≤
address3
≤
last program memory address
Examples
Format (1)
>pm 200 2ff 280
↵
... Copies the codes within the range from address 0x200 to address 0x2ff
to the area from address 0x280.
Format (2)
>pm
↵
Start address ? 200
↵
... Source area start address is input.
End address ? 2ff
↵
... Source area end address is input.
Destination address ? 280
↵
... Destination area start address is input.
>
∗
Command execution can be canceled by entering only the [Enter] key and nothing else.
Notes
• The addresses you specified must be within the range of the program memory area available with
each microcomputer model.
An error results if the input one is not a hexadecimal number or not a valid symbol.
Error : invalid value (no such symbol / symbol type error)
An error results if the limit is exceeded.
Error : Address out of range, use 0-0xXXXX
• An error results if the start address is larger than the end address.
Error : end address < start address
• When the contents of the program memory is modified using the pm command, the contents of the
[Source] window are updated automatically.
• Although the contents of the unassemble display are modified by rewriting code, those of source
display remain unchanged.
GUI utility
None