Epson S5U1C63000A - Manual (Page 121)

CHAPTER 6: HEX CONVERTER
S5U1C63000A MANUAL EPSON 107
(S1C63 FAMILY ASSEMBLER PACKAGE)
6.4 Messages
The hex converter delivers all its messages via the Standard Output (stdout).
Start-up message
The hex converter outputs only the following message when it starts up.
Hex converter 63 Ver x.xx
Copyright (C) SEIKO EPSON CORP. 1998-2001
End message
The hex converter outputs the following messages to indicate which files have been created when it
ends normally.
Created hex file .HSA
Created hex file .LSA
Created hex file .CSA
Created error log file HX63.ERR
Hex conversion 0 error(s) 0 warning(s)
Usage output
If no file name was specified or an option was not specified correctly, the hex converter ends after
delivering the following message concerning the usage:
Usage: hx63 [options]
Options: -b Do not fill unused memory with 0xff
-e Output error log file (HX63.ERR)
-i Use Intel Hex format
-o Specify output file name
File names: Absolute object file (.ABS)
ICE parameter file (.PAR)
When error/warning occurs
If an error occurs, an error message will appear before the end message shows up.
Example:
Error : No ICE parameter file specified
Hex conversion 1 error(s) 0 warning(s)
In the case of an error, the hex converter ends without creating an output file.
If a warning is issued, a warning message will appear before the end message shows up.
Example:
Warning : Output file name conflict
Hex conversion 0 error(s) 1 warning(s)
In the case of a warning, the hex converter ends after creating the output files, but the result cannot be
guaranteed.
For details on errors and warnings, refer to Section 6.6 "Error/Warning Messages".