beautypg.com

Cleaning/maintenance, Gb mt – Florabest FGS 72 A1 User Manual

Page 31

background image

31

GB MT

become blocked by solid objects,

switch off the unit at once.

• Check the grass and bush trimmer

blades for obvious defects such as

loose, worn or damaged parts. Check

that the screws are seated firmly in the

blade block.

• Remove the power supply unit before

working with the equipment. Do not

use extension cables. The power sup-

ply unit is to be used only in enclosed

spaces.

• Only use sharp blades to achieve a

good cutting performance and pre-

serve the battery.

• Do not work the unit so hard that it

comes to a standstill.

• Pay attention to the instructions on unit

maintenance and cleaning.

Use as a grass trimmer

• Grass is best cut when dry and not too

long.

• The telescopic shaft (12) makes it

easier to work with the grass trimmer:

Push the equipment slowly over the

ground on the rollers. This will give an

even cutting height.

Adjusting the length of the telesco-

pic shaft:

• Adjust the length of the telescopic shaft

tyour size with the help of the adjusting

screw (18).

Adjusting the working angle:

For a comfortable edge cut, the equipment

holder (20) can be rotated by 90° to the

right or left on the telescopic shaft rotary

joint (19).

• Set the desired working angle by turn-

ing the telescopic shaft equipment

holder (20). The holder clicks into the

desired position.

Use as a hedge trimmer

Do not use the shrub cutter

in combination with the tel-

escopic shaft. There is a risk

of cut wounds.

• Move the unit forward evenly.

• The double-sided cutting heads enable

cutting in both directions or by swing-

ing the unit from side to side.

Cleaning/Maintenance

Leave any work not covered

in this manual to our Service

Centre. Only use original

parts. There is a risk of in-

jury!

Never use cleaning agents or sol-

vents, which can cause irreparable

damage to the unit. Chemicals can

attack the plastic components on

the unit.

Wear gloves when handling the

blades (

9/11). There is a risk of

injury from cuts!

Clean and service the unit regularly as fol-

lows. This guarantees a long life for your

unit:

• Check the covers and guards for dam-

age and correct position. If necessary,

replace.

• Keep the ventilation slits, motor hous-

ing and handles on the equipment