beautypg.com

Assembling instructions, Gb mt – Florabest FGS 72 A1 User Manual

Page 29

background image

29

GB MT

Charge the battery only in

dry areas.

Do not switch on the equip-

ment during charging.

There is a risk of injury from

electric shock.

Ensure that the equipment is

charged for no longer than

3-5 hours without interruption. The

battery and equipment could be

damaged and they consume energy

unnecessarily in case of longer

charging time. Overcharging invali-

dates the guarantee.

• Before initial use, charge the battery

installed in the equipment. Do not

charge the battery for several short pe-

riods in succession.

• Use the charger supplied to charge

the Li-ion battery installed in the equip-

ment.

• Recharge the battery if the equipment

runs too slowly.

• In all cases, observe the applicable

safety information as well as the regu-

lations and directions for environmen-

tal protection.

• Defects resulting from improper han-

dling are not subject to the guarantee.

1. Connect the charger cable plug

(24) with the charger socket on

the tool (5).

2. Connect the power supply unit

(23) to a socket.

The charging indicator (4) lights

up:

Red: Equipment charging.

Green: Charging finished.

The recommended charging time

is max. 3 – 5 hours.

3. After the recharging process

is completed, first unplug the

charger from the wall outlet, and

then remove the charger cable

plug from the tool.

Assembling instructions

Inserting/replacing the blade

Before replacing the blade,

ensure that the equipment is

switched off in order to avoid

danger and injuries!

Inserting the blade

1. Place the device (1) on the grass

shears blade (9) or the shrub

shears blade (11) so that the ar-

rows and markings are aligned

on top of each other.

2. Push the end of the blade

towards the unlock button

(7). It clicks audibly into

place.

Removing the blade:

3. Push the unlock button (7) up-

wards on the equipment and

remove the entire blade.

If the eccentric holding fixture (25)

of the blade is twisted, it must be

turned manually until the blade

(9/11) can be mounted.

Assembling the telescopic

shaft

For packaging reasons, the tel-

escopic handle

(12)

is delivered

in two sections. When connected

together, the two sections lock into

each other and cannot subsequent-

ly be detached.