Florabest FGS 72 A1 - Manual (Page 30)

30
GB MT
Connecting the telescopic
tubes:
1. Put both parts of the telescopic
tube (16) together up to the stop.
They snap into place.
While putting them together
make sure that the nose (16a)
of the upper telescopic tube fits
into the notch (16b) of the lower
telescopic tube.
2. Push the adjusting screw (18) up
and screw tightly .
Ensure that the mains cable is
not caught.
Assembling the rollers:
3. Remove one wheel (21) from the
axle.
4. Push the axle through the holes
on the telescopic shaft and
reconnect the wheels and axle
(21).
Assembling/dismantling the
telescopic shaft
1. Push the equipment (1) into
the telescopic shaft equipment
holder (20). It clicks audibly into
place.
2. Plug the plug connection (17)
into the charging socket (5) on
the back of the equipment han-
dle (3).
3. To dismantle, release the plug
connection (17) and pull the
equipment out of the telescopic
shaft equipment holder (20).
Operation
Keep to noise abatement regula-
tions and other by-laws.
Switching on and off
1. Remove the blade guard (
8/10) before switching the unit
on.
2. - To switch on, hold the switch
lock (2) depressed and oper-
ate the on/off switch (6). Then
release the switch lock.
- To switch on the equipment
when using the telescopic
shaft (12), operate the switch
lock (13) and on/off switch
(15) on the telescopic shaft.
The equipment runs at top
speed.
3. In order to switch off, let go of
the on/off switch (6/15).
When using the telescopic shaft, the unit
can only be switched on and off at the
shaft handle.
After switching the unit
off, the blades take a short
time to stop moving. Let the
blades come to a complete
standstill. Do not touch the
moving blades and do not
try to stop them moving. In-
jury hazard!
General working instructions
While trimming, take care that there
are no objects such as wire, metal
parts, stones etc. come into contact
with the blades. This can lead to
cutting head damage. If the blades