Enterasys Networks Enterasys Gold Distributed Forwarding Engine 4H4285-49 - Manual (Page 30)

Installation Site Requirement
3-2 Installation
Installation Site Requirement
The 4H4285‐49 must be installed in a Matrix N3 or N7 chassis located in a Restricted
Access Location (RAL). This location should only be accessible by people that have been
trained or are technically competent enough to be aware of potential risks of accessing the
hazardous areas of the chassis. Locations such as a locked wiring closet or locked cabinet
meet this requirement.
Unpacking the DFE Module
Unpack the DFE module as follows:
1. Open the box and remove the packing material protecting the DFE module.
2. Verify the contents of the carton as listed in Table 3‐1 .
3. Remove the tape seal on the non‐conductive bag to remove the DFE module.
4. Perform a visual inspection of the DFE module for any signs of physical damage.
Contact Enterasys Networks if there are any signs of damage. Refer to
“Getting
Help” on page xviii for details.
Warning: Install this module in a Matrix N3 or N7 chassis that has been installed in a
Restricted Access Location only. Access to the equipment by users must be restricted
through the use of a tool or lock and key or other means of security and is controlled by
the authority responsible for the location.
Advertencia: Instalar este modulo en un Matrix N3 o N7 que ha sido localizado en un
lugar de Acceso Restringido. Aceso al equipo debe ser restringido por el responsable del
sitio.
Warnhinweis: Installieren Sie dieses Modul nur in einem N3 oder N7 Chassis, wenn sich
diese in einer zugangsgeschützten Umgebung befinden. Der Bereich zu den
Komponenten sollte durch ein Schloß, einen Schlüssel oder sonstigen Sicherungen
geschützt und durch einen Verantwortlichen kontrolliert werden.
Table 3-1 Contents of DFE Module Carton
Item Quantity
DFE module 4H4285-49 1
Installation Guide 1
Customer Release Notes 1