Florabest FSG 85 B1 - Manual (Page 49)

49
GB MT
Ensure that the disk dimensions
fit the equipment.
• Use only fault-free grinding disks
(ring test).
• If the locator hole in a grinding disk
is too small, do not subsequently
redrill in order to increase the size.
• Do not use separated reduction
bushes or adapters in order to
make a grinding disk fit where the
hole is too large.
• Do not use saw blades.
• Reassemble the equipment fully
after changing the grinding disk.
Switch off the equipment and dis-
connect from the mains.
Allow the equipment to cool.
1. Unscrew the grinding disk cover
(3).
2. Remove the grinding disk nut
(18b) by hand.
3. Take the grinding disk (18a) off
the adapter.
4. Place a new grinding disk on the
adapter and tighten the grinding
disk nut by hand.
5. Put the grinding disk cover (3)
back on.
Do not tighten the grinding disk nut
too much because this may cause
the grinding disk and nut to break.
6. Test run: Before starting work and af-
ter each change of grinding disk, carry
out a test run of at least 30 seconds
with no load. Switch off the equipment
immediately if the disk runs lumpy,
substantial vibrations occur or abnor-
mal noises are generated.
Storage
• Store the appliance in a dry place well
out of reach of children.
Grinding disks must be stored
dry and upright and are not to be
stacked.
Waste disposal and envi-
ronmental protection
Be environmentally friendly. Return the tool,
accessories and packaging to a recycling
centre when you have finished with them.
Machines are not to be place with
domestic waste.
Hand over the device at an utilization
location. The plastic and metal parts em-
ployed can be separated out into pure
materials and recycling can be implement-
ed. Ask your Service Center about this.
Defective units returned to us will be dis-
posed of for free.
Guarantee
• This appliance has a 36-month guar-
antee; a shorter 12-month guarantee
applies if the appliance is to be used
for commercial purposes or for re-
placement appliances according to
statutory regulations.
Justified guarantee claims should
be reported to our Service Centre
(see page 57 for telephone & fax
no.s, and email address). Our Serv-
ice Team will tell you more about
our complaints handling procedure.
• Damage due to natural wear and tear,
overload or incorrect use is excluded