Florabest FSG 85 B1 - Manual (Page 46)

46
GB MT
(24) from the package to attach
the grinding plinth to the worktop.
Assembling the grinder:
5. Screw the handle (4) into the
grinding head (2).
6. Remove the locking screw (10)
from the chain clamping unit
(12).
7. Place the chain clamping unit
(12) on the grinding plinth (8)
and fix it using the locking screw
(10).
8. Snap the mains lead (17) into
the cable hook (16).
Screwing on the adjusting
screw:
9. Press the nut (25) from the pack-
age into the recess in the grind-
ing head (2) and screw on the
adjusting screw (6) to the grind-
ing head.
Working with the equip-
ment
Caution!
Use only grinding disks and acces-
sories recommended by the manu-
facturer. The use of other insertion
tools and other accessories may
cause risk of injury.
Never operate the device without
the visual protection disk.
Do not use saw blades.
Check the grinding disk before use:
check the distance between the
protective screen and the grinding
disk. Do not use broken, cracked or
otherwise damaged grinding disks.
Switch on the equipment only when
it is safely installed on the work sur-
face. There is a risk of injury.
Risk of injury!
Wear ear, eye and hand protection!
When working with the saw chain,
wear cut resistant gloves and an
apron if necessary, to avoid inci-
sion injuries.
Keep hands away from the grind-
ing disk and chain teeth when the
equipment is in use. Do not move
the chain by hand. There is a risk
of injury.
Switching on and off
Ensure that the mains voltage
matches the specifications on the
rating plate.
Connect the equipment to the
mains.
1. To switch on, press the on/off switch
(“ I“ position); the equipment starts up
(see 1).
2. To switch off, press the on/off switch
(“ 0“ position); the equipment switches
off (see 1).
The disk will continue to run
after the equipment is switched
off. There is a risk of injury.
Protection against overheating and
restart:
The unit will not automatically restart fol-
lowing an automatic cutout due to over-
load.
To restart the grinder, press the On/Off
switch (“ I“ position). The unit will start
(see 1).