Crivit 1-LD3322 User Manual
Page 15

- 85 -
entering the heart rate display mode. The available channels are CH10, CH11, 
CH12, CH13 and CH14. 
The channel can be changed by briefly removing the battery from the chest best 
and reinserting it. The chest belt will randomly select a channel and after approx. 1 
minute the heart rate and the new channel will appear on the display of the watch. 
 
Troubleshooting 
 
The heart rate is not shown or is shown incorrectly
The heart rate is not shown or is shown incorrectly
The heart rate is not shown or is shown incorrectly
The heart rate is not shown or is shown incorrectly 
Make sure the chest belt is positioned correctly and fits well. 
Your skin should not be too dry or too cold. 
The contact areas can be slightly moistened to improve function. 
Electromagnetic interference may have an adverse effect on reception. 
The distance between watch and chest belt must be under 70cm. 
Other heart rate measuring devices within a 2m range may also cause 
interference. 
Wireless bicycle computers may cause interference. 
The batteries may be low and require replacing. 
 
The display is unreadable / the light does not work
The display is unreadable / the light does not work
The display is unreadable / the light does not work
The display is unreadable / the light does not work 
Replace the batteries. 
 
Replacing the heart rate monitor battery
Battery replacements must be performed by an expert to avoid damaging the case 
or gaskets. 
 
Battery low indicator
If the battery voltage on the chest belt battery drops below the voltage required for 
normal operation, 
TXBELT
LO BAT
TXGURT
BATT
SNGLTX
PILE
TXBCIN
BAT BA
- 86 -
will appear on the display. Replace the battery of the chest belt as described in the 
chapter "Chest belt".
Water resistance of the heart rate monitor
Water resistant up to 3 bar. The bar value specifies the atmospheric overpressure 
which is applied during testing (DIN 8310). 
 
 
 
Water resistance of the chest belt 
Water resistance according to IEC 60529 IPx7: 30m 
 
Cleaning instructions
Clean the product with a soft, dry and lint-free cloth. A glasses cleaning cloth is 
ideal. 
 
Disposal of the electronic appliance
This electronic appliance may not be disposed of with normal household 
waste. Dispose of the unit at an approved disposal facility or at your local 
recycling centre. Please observe the current rules and regulations when disposing 
of the appliance. Contact the disposal system if in doubt. 
 
- 87 -
Disposal of the batteries
Please dispose of your batteries properly in containers especially set up 
at retailers. Batteries do not belong in household waste. Dispose of the batteries at 
an approved disposal facility or at your local recycling centre. Contact the 
disposal system if in doubt. 
 
Declaration of conformity
If used as intended this product conforms to the basic standards of § 3 and the 
other relevant provisions of the FTEG (Section 3 of the R&TTE directive). 
You can request the declaration of conformity here: 
[email protected] 
 
digi-tech gmbh warranty
This watch includes a 3 year warranty starting on the day of purchase. In case of 
defects of this heart rate monitor you have, by law, certain rights regarding the 
vendor of the heart rate monitor. These rights are not changed by the warranty 
which is described in the following paragraphs. 
 
Warranty conditions
The warranty duration starts on the date of purchase. Please keep the original 
receipt in a safe place. The receipt is needed as a proof of purchase. If a defect 
occurs in the heart rate monitor within 3 years, the heart rate monitor will be 
repaired or replaced (according to our choice) free of charge. This warranty 
requires that, within the 3 year warranty period, the watch and the receipt can be 
made available to us along with a short written description of the defect and when 
it occured. If the defect is covered by the warranty, you will receive the repaired 
heart rate monitor or a new heart rate monitor. Repair or replacement does not 
cause the warranty period to restart. 
 
Warranty period and defects liability
The warranty period is not increased by the defect liability. This also applies to 
repaired or replaced parts. If defects are noticed at the time of purchase they must 
- 88 -
be reported immediately upon unpacking the item. Paid repair may be available 
after the end of the warranty period. 
 
Scope of the warranty
The heart rate monitor was manufactured according to strict quality guidelines and 
was carefully inspected before delivery. The warranty does not include parts that 
experience normal wear and tear and can thus be seen as wear parts or fragile 
parts that are damaged. Examples include Switches, Batteries or parts made of 
glass. 
This warranty becomes void if the heart rate monitor is damaged, is not used in the 
recommended way or is improperly repaired. 
For proper use of the heart rate monitor all instructions in this manual must be 
adhered to exactly. Use of the heart rate monitor in a way that is discouraged in 
the manual must be avoided. 
The heart rate monitor not intended for commercial use. Abusive or improper use, 
excessive force and changes that are made by non-authorized repair centers will 
void the warranty. 
 
Warranty claim procedure
To ensure that your call is processed in a fast and efficient manner please note the 
following directions: 
• Have your receipt (as proof of purchase) and the article number (72143) 
handy.
• The article number can be found on the type label, an engraving, the front
page of the manual (bottom left) or a sticker on the back side or bottom side of 
the case. 
• In case defects occur, please first contact the service center (see below) by
first contact the service center (see below) by
first contact the service center (see below) by
first contact the service center (see below) by
phone or email.
phone or email.
phone or email.
phone or email.
Visit www.lidl-service.com to download this and many other manuals, 
product videos and software. 
- 89 -
Service
Name: inter-quartz GmbH 
Email: [email protected] 
Telephone: 00800 5515 6616 
Based in: Germany 
00800 44140855
8009 4403
800 5515 6616
IAN 72143
Supplier
Please note that the following address is not a service address. 
Please first contact the service address (see above). 
 
Name: digi-tech gmbh 
Street: Valterweg 27A 
Town: Eppstein 65817 
Country: Germany 
IAN 72143
digi-tech gmbh 
Valterweg 27A 
D-65817 Eppstein 
 
 
Actualización de las informaciones 
Edizione del foglio di informazioni 
Data das informações 
Stand der Informationen 
Last information update: 
2/2012 · Art.-Nr.: 1-LD3322 
 
