Emerson Radio iC172 - Manual (Page 24)

2 4
Listening To Your “Dockable” iPod / Charging The Battery
IMPORTANT!
To prevent distortion during iPod playback you should go to the Main
Menu of your iPod, select the Settings Menu page, select the EQ Setting,
and make sure that the EQ function is set to “Off”.
(Main Menu > Settings Menu > EQ Setting > Select “Off”)
This system provides an iPod docking station on the top panel. You can connect
any “dockable” iPod to this system using the plastic docking adapter that was
supplied with your iPod or, if you have an older model iPod that was not supplies
with a docking adapter, use one of the 5 adapters included with this system.
When your “dockable” iPod is in the docking area, the power to your device is
being supplied by this system, not by the iPod’s internal battery. In addition when
your iPod is switched ‘Off’ while resting in the dock the internal iPod battery is
automatically recharged.
NOTES :
• MAKE SURE to disconnect the the AUX plug before playing the iPod.
• To prevent any possible interference between the iPod and the Tuner in
this system, the iPod battery circuit is automatically switched ‘Off’ while you
are listening to the radio. When the radio is ‘Off’ the battery charging circuit
switches ‘On’ again automatically, regardless of whether the Power button
of this system is ‘Off’ or ‘On’.
Follow these steps to connect and listen to your iPod. We recommend that you
start with the power to this system switched ‘Off’:
1.) Use the adapter supplied with your iPod or select the correct adapter for your
oder iPod from among the 5 adapters included. Refer to the chart on Page 23.
Place the adapter in the docking area so that the iPod 30-pin connector passes
through the opening in the adapter.
Gently press downward on the adapter until it “clicks” and locks in place.
iC172 IB 301207new3.p65 26/3/2008, 11:11 24