Emerson Radio iC172 - Manual (Page 13)

1 3
Listening To The Radio
Digital Radio Frequency Display
This clock radio features a digital radio frequency display instead of a dial scale to
make tuning easier, especially in a dark room. The jumbo LED time display
automatically changes to a radio frequency display as soon as you begin turning
the TUN. (Tuning) control. And the display automatically changes back to the
correct time within 10 seconds after you release the TUN. (Tuning) control.
1.) Set the Band FM/AM selector switch to the desired band, AM or FM.
2.) Press the POWER button to turn the system ‘On’. The display will briefly
show “rd” to confirm that the Radio mode is selected. The AM or FM frequency
will appear.
3.) Turn the TUNING control counter-clockwise to select higher numbered
frequencies or clockwise to select lower numbered frequencies.
Important: It is not necessary to tune to the exact frequency of your
desired station. Just rotate the TUN. (Tuning) control until you find
the strongest signal and the best reception, even if the frequency
number on the display is higher or lower than the actual station
frequency.
Within 10 seconds after you release the TUN. (Tuning) control the display
automatically changes back to the correct time.
4.) Press the VOLUME + ( ) or VOLUMN - ( ) buttons to set the volume to
the desired level. The display changes to the volume level indication when
you press the volume buttons. The adjust range is from “0” (Minium) to “32”
(Maximum).
5.) When you are finished listening, press the POWER button to turn the radio
‘Off’.
iC172 IB 301207new3.p65 26/3/2008, 11:11 13