Emerson Radio iC172 - Manual (Page 15)

1 5
Wake To Radio
1.) Turn the radio ‘On’ and select the band, station, and volume level that you
wish to hear when the alarm comes ‘On’, then turn the radio ‘Off’ again.
2.) Reconfirm the wake up time and alarm mode settings for the alarm you are
using, Alarm 1, Alarm 2, or both alarms.
3.) Set the ALARM selector switch for one or both alarms to the “RADIO” position.
The appropriate AL 1 and/or AL 2 indicators will light up to confirm that the
alarms are set.
4.) At the selected wake up time the radio will turn ‘On’. It will play for one hour
and then shut off automatically.
5.) To stop the radio sooner, press either the appropriate ALARM 1 or ALARM 2
button, or press the POWER button. The radio will stop but the alarm
remains set and will turn the radio on again at the same time on the following
day (depending on the Alarm Mode setting).
6.) If you do not want the alarm to turn the radio on the following day, set the
appropriate ALARM selector switch to the “OFF” position.
Wake To Buzzer (Crescendo Alarm)
Note: Alarm 1 and Alarm 2 have different buzzer sounds.
• Alarm 1 is a “Single beep” sound.
• Alarm 2 is a “Double beep” sound.
You will be able to tell which alarm is going off by the sound that it makes.
1.) Reconfirm the wake up time and alarm mode settings for the alarm you are
using, Alarm 1, Alarm 2, or both alarms.
2.) Set the ALARM selector switch for one or both alarms to the BUZZ position.
The appropriate AL 1 and/or AL 2 indicators will light up to confirm that the
alarms are set.
iC172 IB 301207new3.p65 26/3/2008, 11:11 15