Crivit 1-LD3604-х - Manual (Page 33)

- 63 -
Calories, fat burn and BMI (KALORIEN/CALORIE)
The lower row will show the burned calories in kcal (KALORIEN/CALORIE).
Press SET to switch to the display of fat burn in gram (FETT/FAT BURN) or to the
display of your BMI (Body Mass Index).
In the display for calorie burn or fat burn the values can be reset by pressing and
holding SET.
Note: To increase the accuracy of the calorie and fat burn displays your age and
weight must be set correctly.
Note: The counter for fat burn is only activated while your heart rate is above 120
beats per minute.
Notes on the BMI
The BMI is a statistical measurement that can be used to judge a persons weight.
For adults, a value between 18.5 and 25 is considered normal. Values below
18.5 are considered "underweight". Values above 25 are considered
"overweight". Values above 30 are considered "Obese".
The BMI is only a coarse guideline because it does not take a persons body type
and body composition into consideration.
Pedometer (PEDO)
START appears on the display. Press SET to start the pedometer. The speed
(PEDO) or the travelled distance (DISTANZ/DISTANCE) will appear in the lower
row of the display. Press SET to switch between speed and distance.
Fitness (FITNESS NIVEAU/FITNESS LEVEL)
After your training, immediately press SET. A 5 minute countdown will start (cool
down phase).
The bar will show the remaining time. On the left side of the display the heart rate
at the beginning of cool down is shown. On the right side of the display the current
heart rate is shown. The countdown time is shown on the bottom row of the
display.
- 64 -
After 5 minutes your fitness level will appear.
Fitness level
Heart rate
6 (-) >130
5 130-120
4 120-110
3 110-105
2 105-100
1(+) <100
Step counter (PEDO)
Press MODE to select the (PEDO) feature before proceeding.
Press SEL to select the subfeatures of the pedometer.
calibration and speed alarm (ZONE) > total distance (GESAMT-
DIST/ODOMETER) > step counter (SCHRITTE/STEP) > calorie burn, fat burn
and BMI (KALORIEN/CALORIE) > heart rate (PULS/HRM) > timer (TIMER) >
distance (DISTANZ/DISTANCE) > average speed (DURCH-GESCW/AVG
SPEED) > maximum speed (MAX GESCHW/MAX SPEED)
The current speed is shown on the middle row of the display.
IMPORTANT: The pedometer can be stopped or started by pressing SET. When
the pedometer is active an animated figure will move in the top left of the display.
Speed alarm (ZONE)
In the lower part of the display to lower and upper limits for the target speed are
shown. The current speed will appear in the middle row. The speed alarm can be
activated or deactivated by pressing and holding SEL. If the alarm is activated the
alarm symbol will appear.