Kichler 337214 - Manual (Page 3)

Fig. F
Fig. G
Receiver to Supply Wires: Figure E
Green fan wire to...............................Green or copper Household supply wire
Black receiver wire marked AC In L to........ Black Household supply wire
White receiver wire marked AC In N to........White Household supply wire
Receiver to Fan wires: Figure E
White receiver wire marked TO MOTOR N to..............White wire from the Fan
Black receiver wire marked TO MOTOR L to...............Black wire from the Fan
Blue receiver wire marked FOR LIGHT to.....................Blue wire from the Fan
Fig. E
AC SUPPLY
BLACK
WHITE
BARE GREEN
WHITE
WHITE
BLUE BLUE
BLACK
BLACK
WHITE BLACK
RECEIVER
OUTLET BOX
CAUTION: If the household supply wires are a different color
than described here, it's recommended that you have a qualified
electrician make these connections.
d. Push all connected wires up into junction box.
e. Reinstall the canopy on the mounting bracket. (Fig. C)
CoolTouch TM control system
2
3. OPERATING INSTRUCTIONS
The Universal CoolTouch™ Transmitter can be used outdoors
without any concern. However, it should be mounted indoors away
from excess heat and not allowed to come into contact with water or
excess humidity.
A. Remove the back cover on the transmitter and install both, 3 volt
(#2032) batteries that were included with the remote control. Make
sure the + sign is facing up and be careful NOT to move any of the
small frequency dip switches. (Fig. F)
Replace the battery cover.
B: To prevent possible damage to the transmitter, remove these
batteries if not used for long periods of time (months).
C. ●, ●●, ●●● Buttons:
These Buttons are used to set the fan speed as follows:
●●●
= Low Speed
●● = Medium Speed
● = High Speed
B. " " Button:
This button turns the fan motor off.
The " " Button:
Incandescent Lamps - Press and Release for On/Off - Press and HOLD for
Full Range Dimming, release at the desired brightness level. You can turn
the lamps On and Off at any level.
Fluorescent Lamps - Press and Release for On/Off. The Dimming function
is disabled for fluorescent lamps.