Kichler 337214 - Manual (Page 2)

GENERAL INFORMATION
The Universal CoolTouch™ Control System is designed for Indoor or
Outdoor use. It will separately control your Ceiling Fan Speeds and the
Light Fixture (if equipped). This control system does NOT remotely control
the forward/reverse function.
Transmitter Control Buttons
● Speed Settings Low - Medium - High
● Motor Off
● Light Fixture, On/Off
1. INSTALLATION AND SET-UP:
The Universal CoolTouch™ Control System is a RF (Radio Frequency)
remote control with adjustable frequencies.
The Frequency Selector is a "Dip Switch Block" inside the Battery
compartment of the Transmitter (see figure A) and on the Receiver Unit (see
figure B). You change frequencies by arranging the small switches
numbered 1 through 4 in a up or down position.
1. SETTING THE OPERATIONAL FREQUENCY:
A. Setting the Transmitter Frequency:
a. Remove the battery cover on the back of the transmitter by pressing on
the cover lid at the point indicated in Figure A.
b. Arrange the “Dip Switches” 1 through 4 in any order you wish (up or
down)
c. If your fan is equipped with a Light Fixture, the fifth switch, marked D
and ON sets the system for operation with Incandescent or Fluorescent
Lamps. It is essential to set this switch correctly or you could damage
the lamps and/or fixture.
i. Incandescent Lamps = Set the switch to D
ii. Fluorescent Lamps = Set the switch to ON
d. Use a small flat bladed screw driver to move the switches.
B. Setting the Receiver Frequency:
a. The Frequency Selector on the Receiver is located under a rubber plug
on top of the receiver and has only four switches ( 1 through 4 ).
b. Remove the rubber plug and match the position of each switch on the
Receiver to the same position on the Transmitter. This sets both the
Receiver & Transmitter to the same frequency.
c. Replace the rubber plug. This will keep water and moisture out of the
receiver unit.
2. INSTALLING THE RECEIVER
WARNING: HIGH VOLTAGE !
Household electrical power can cause
serious injury or death. Make sure the electrical power source is turned OFF
at the main panel by removing the circuit fuse or switching the circuit
breaker OFF.
A. Installing the receiver unit:
a. Rotate the mounting screw cover on the canopy counter clockwise,
loosen the two mounting screws, rotate the canopy counter clockwise and
let them rest on top of the motor housing.
b. Disconnect the existing electrical wiring between the ceiling
fan and the household supply wires in the ceiling outlet box.
c. Slide the receiver unit into the open space between the top of
the mounting bracket and the mounting ball with the "flat"
side of the receiver facing UP. (Fig. C or D)
The CoolTouch™ Receiver Unit is adaptable to the Kichler ® Basic
Mounting System (Fig. D) as well as the Kichler ®
Slope Adaptor Mounting
System (Fig. C)
Code switches
Press Here
Code switches
Mounting Screw
Cover
Receiver
Transmitter
Fig. A
Fig. B
Fig. C
Fig. D
ON
1
RECEIVER
RECEIVER
ON ECE
1 2 3 4 ON
D