Kichler 380108 - Manual (Page 3)

2
Palla Light Kit
TM
Step 1. Loosen the three mounting screws
located on the light plate. (Fig. 2)
Step 2. Hold the light kit close to the light
plate and connect the white wires from the
light kit and the ceiling fan by pushing
them together unit they "click" into place.
Follow the same procedure for the black wires.
Step 3. Tuck the wire connections neatly
into the light plate.
Place the light kit key holes over the three
mounting screws on the light plate. Rotate
the light kit until the screws are at the narrow
end of the key hole slots. Securely tighten
all three screws.
Remove the bottom decorative cap by turning
it counter clockwise. (Fig. 1)
./4% This decorative cap is not used after
the light fixture is installed. However, it's a
good idea to save it incase you want to remove
the light fixture at some later date.
Bottom Cap
Light plate
Light Kit
Screw
Connection Plugs