Edirol PC-50 - Manual (Page 34)

34
Getting Connected and Installing Drivers (Macintosh)
13
Exit OMS Setup .
From the File menu, choose [Exit] . If the AppleTalk confirmation dialog box
appears, click [OK] to close the dialog box.
■
FreeMIDI settings
1
Set the PC-50’s ADVANCED DRIVER Switch to the ON position.
* Installation cannot proceed as described below if the switch is turned OFF.
2
Use the USB cable to connect the PC-50 to your computer.
1. Set the PC-50’s power switch to the OFF position.
2. Use the USB cable to connect the PC-50 to your computer.
3
Set the PC-50’s power switch to the USB position.
* Connect the cable to the USB connector of the Macintosh itself, not to the USB
connector of the keyboard.
4
From the CD-ROM, drag the Driver E (Mac OS 9,8) - FreeMIDI Setting
folder into the FreeMIDI Applications folder on the hard disk of your
Macintosh to copy it there.
5
Open the FreeMIDI Applications folder from the location into which you
installed FreeMIDI , and double-click the FreeMIDI Setup icon to start it up.
6
The first time you start up, use the following procedure.
1. A dialog box saying “Welcome to FreeMIDI!” will appear.
Click [Continue] .
2. The FreeMIDI Preferences dialog box will appear.
Click [Cancel] .
3. The About Quick Setup dialog box will appear.
Click [Cancel] .
This completes installation of the driver.
Next, make MIDI device settings in your sequencer or other software.
For details on how to make these settings, refer to the owner’s manual for your software.
For details on the PC-50’s input / output devices, refer to “Input / output devices” (p. 36).
Once the connections have
been completed, turn on
power to your various
devices in the order
specified. By turning on
devices in the wrong
order, you risk causing
malfunction and/or
damage to speakers and
other devices.
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after power up is required
before the unit will operate
normally.
If you are using the PC-50
in conjunction with other
MIDI devices, make
settings as described in
Readme_E.htm
located in
the Driver E (Mac OS 9,8)
folder of the CD-ROM.
When “OMS is installed
on this computer...”
appears, click [FreeMIDI].
PC-50_e.book 34 ページ ２００５年１１月１０日 木曜日 午前１０時３３分