Edirol PC-50 - Manual (Page 31)

31
Getting Connected and Installing Drivers (Macintosh)
Use either OMS or FreeMIDI as the MIDI driver.
The included PC-50 driver is an add-on module for using the PC-50 with
OMS or FreeMIDI.
* Either OMS or FreeMIDI must be installed in your Macintosh, as appropriate for
the sequencer software you are using.
Use the following procedure to install the PC-50 driver.
1
Exit all currently running software.
If you are using a virus checker or similar software, be sure to exit this as well.
2
Prepare the CD-ROM.Insert the CD-ROM into the CD-ROM drive.
3
Double-click the PC-50 Driver-E Installer icon (found in the Driver E (Mac
OS 9,8) folder of the CD-ROM) to start up the installer.
4
Verify the Install Location , and click [Install] .
fig.05-20
5
If a message like the following is
displayed, click
[Continue] .
The other currently running
softwares will exit, and installation
will continue.
6
A dialog box will indicate Installation was successful .
Click [Restart] to restart your Macintosh.
Installing the driver
OMS can be found in the
OMS 2.3.8 E
folder within
the OMS (Mac OS 9,8)
folder of the CD-ROM. If
you would like to know
more about OMS, refer to
OMS_2.3_Mac.pdf
which
can be found in the same
folder.
If a PC-50 is already connected to your Macintosh when you install the driver,
a message like the following will appear when the Macintosh is started up.
Perform the steps described below as appropriate for the message that is
displayed.
If the screen indicates:
“Software needed for the USB device “EDIROL PC-50” is not available.
Would you like to look for the software on the Internet?” ➔ click [Cancel].
If the screen indicates:
“The software needed to use the USB device “PC-50” cannot be found.
Please refer to the device documentation to install the necessary
software.”
➔ click [OK].
If you install OMS or
FreeMIDI after installing
the PC-50 driver, you must
install the PC-50 driver
once again.
Disconnect the PC-50 from
the Macintosh before you
perform the installation.
The installation location
will be shown differently
depending on your
system. Make sure that
you have selected the
startup disk for the system
you are currently using.
PC-50_e.book 31 ページ ２００５年１１月１０日 木曜日 午前１０時３３分