Enterasys Networks A2H124-24FX - Manual (Page 32)

Installing Optional Mini-GBICs
3-4 Hardware Installation
Installation
To install a Mini‐GBIC that has an RJ45 connector, refer to Figure 3‐1 ; for a Mini‐GBIC
with a MT‐RJ connector, refer to Figure 3‐2 ; for a Mini‐GBIC with an LC connector, refer
to Figure 3‐3 ; and proceed as follows:
1. Hold the Mini‐GBIC with the top side positioned as shown, and the 7‐pin edge
connector facing the port slot.
2. Align the Mini‐GBIC with the port slot.
3. If you are using the RJ45 Mini‐GBIC as in Figure 3‐1 , be sure the release tab is in the
up position.
4. Push the Mini‐GBIC into the port slot until the Mini‐GBIC “clicks” and locks into
place.
Figure 3-1 Mini-GBIC with RJ45 Connector
1 SFP Slot 3 Release tab
2 Mini-GBIC (MGBIC-02) 4 Link/Activity LED
27
28
A2H124-24FX
25
26
27
28
25/Up
26/Do
wn
Stac
k
В
Б
А
Г