Powerplus POWX0782 MITRE SAW +UPPER TABLE 1800W 254MM EN - Manual (Page 9)

POWX0782
EN
Copyright © 2013 VARO P a g e | 9 www.varo.com
You run the risk of injury, if you handle the machine incorrectly when lifting
or turning it. Always hold the machine firmly by the base (12).
 Position the machine on a suitable surface:
 - All 4 feet must rest firmly on the surface.
- The ideal height of the surface is approximately 800 mm.
- The saw must stand firmly in position, even when larger workpieces are being sawn.
 You can keep the packaging for future use, or you can dispose of it separately, based on
the type of material, and it in an environmentally friendly manner.
8.2 Transport (Fig. 5, 12, 13)
 Position the lowest saw blade guard (14) over the saw guide piece (21) and push
backwards until you hear a click, and until he saw blade protector is positioned at the
black line on the saw guide piece.
 Lower the saw head by pushing in the safety lock (6) and activate the locking pin (22).
 Position the mitre guide (4) over the saw blade guard and fasten it.
 Lift the machine up by grasping both sides of the base (12).
Note:
 The essential operating components of the machine are presented in this section.
 Make sure to read this section, before you use the machine for the first time.
8.2.1 Table saw operating mode (Fig. 2, 5, 6, 12)
 Make sure that the table is mounted completely and in the right direction (Fig. 2) – see
Paragraph 7.1 on Transport above - and that the locking pin (22) is properly locked.
 Remove the mitre and width guide (4).
 The ON/OFF switch (7) is used for starting and stopping the machine.
8.2.2 Cross-cut and mitre saw operating mode (Fig. 6)
 Make sure that the mitre and width guide (4) is correctly installed and that the saw blade is
covered. This activates switch A (8). Make sure that the cover (mitre and width guide) is
firmly attached. If this is not the case, use the mitre and width guide locking knob (5) to
fasten it.
 Remove the lower saw blade guard (14).
 For starting the motor, push on the switch (29) in the handgrip.
 To switch off the motor, release the switch (20).
8.2.3 Turntable (Fig. 7-9)
The turntable (11) can be turned 50° to the left and 60° to the right, and it can be fixed in
preset positions of 0°, 15°, 22.5°, 30°, 45° and 60°.
For turning the mitre table, the locking knob (9) must be released.
To prevent that the mitre angle changes while sawing, the locking knob of
the mitre saw must be tightened (also when the saw has been fixed at a
preset stop).