beautypg.com

Electrical safety, Special product characteristics, Installation and transport – Powerplus POWX0782 MITRE SAW +UPPER TABLE 1800W 254MM EN User Manual

Page 8: Installation (fig. 14)

background image

POWX0782

EN

Copyright © 2013 VARO

P a g e

| 8

www.varo.com

 The hazard to your health from such exposures is dependent on how frequently you do

this kind of work.

 Measures for reducing your exposure to such chemicals: Always work in well-ventilated

surroundings and with certified safety equipment, such as dust masks that have been
specially designed for filtering out microscopic particles.

 For sawing operations, connect the equipment to a dust exhaust system.
 The guard may be lifted up while positioning a workpiece, or for easier access during

maintenance works. Make sure that the saw guard has been lowered and is positioned flat
against the sawing table, before connecting your tool to the mains supply.

6 ELECTRICAL SAFETY

Check the voltage that is documented on the type plate of the machine, to
make sure that it corresponds to the locally available mains voltage.Safety
class II.

7 SPECIAL PRODUCT CHARACTERISTICS

 Quick change-over between cross-cut and table saw mode.
 90° sawing range for bevelling (45° left or 45° right) with five preset stops
 110° sawing range for mitre sawing (50° left or 60° right) with ten preset stops
 Perfectly suited for mobile use, due to its low weight and small dimensions
 Robust, cast aluminium construction for precision sawing
 TCT saw blade
 Installation of additional guides possible
 After an interruption of the power supply, a restart protection prevents that the machine

starts up again when the power supply is restored.

8 INSTALLATION AND TRANSPORT

Do not carry the machine on the handgrip; the handgrip is not designed to
carry the full weight of the machine. For carrying the machine, hold it on
both edges of the base (12).

8.1

Installation (Fig. 14)

 Get help from another person for lifting the machine out of the box.
 Turn the turntable into the 0° position and tighten up the mitre locks.

 Note:
 If the machine must be mounted on a workbench, then the rubber feet should NOT be

installed.


 To install the rubber feet, turn the machine carefully to the right, so that it is supported by

the motor.

 Insert the nut (A3) in the hole at the lower side of the rubber feet.
 Insert the main socket screw (A1) in the machine at the upper side. Fasten the rubber feet

(A2) with the previously inserted nut (A3) to screw (A1).

 Only use your hands for tightening the rubber feet.
 Use the hexagonal spanner for tightening the screw.