Powerplus POWX0782 MITRE SAW +UPPER TABLE 1800W 254MM EN - Manual (Page 11)

POWX0782
EN
Copyright © 2013 VARO P a g e | 11 www.varo.com
 Do not use the power cable for pulling the plug out of the socket.
9 OPERATIONS
Read the instructions.
Wear safety goggles and ear
protection
Do not touch a turning saw
blade.
Wear a dust mask.
This saw can be used as a:
 Cross-cut saw
 Table saw
Before making any changes in the settings of this machine, always remove
the plug from the socket.
9.1 Cross-cut sawing mode
9.1.1 Safety instructions for the movable saw blade guard (Fig. 16)
The movable saw blade guard (C1) protects against accidental contact with the saw blade and
flying wood splinters.
The movable saw blade guard must always return automatically to the start position, whenever
the saw head is lifted. The saw blade must be covered at all sides, when the saw head is
located in the start position.
9.1.2 Safety lock (Fig. 2-3)
The safety lock (6) blocks the saw head in the topmost position, and it prevents that the
movable saw blade guard exposes the saw blade.
The safety lock is released by pushing on it. The saw head (19) can now be lowered; as the
saw head is lowered, the saw blade guard retracts and the saw blade is freed.
After a cut has been made, and when the saw head is back in the topmost starting position,
the movable saw blade guard is once more blocked by the safety lock.
9.1.3 Installation (Fig. 12 and 13)
HAZARD!
Before starting with the installation of the machine:
- Switch the machine “OFF”
- Remove the plug from the socket
- Wait until at the machine has come to a complete standstill
 The mitre and width guide (4) must be installed, so that the saw blade can be covered and
safely fastened. The mitre and width guide must activate switch A (8); secure the position
with the mitre guide locking knob (5).
 Release the locking knob (22) and lift up the saw head completely
 Remove the lower saw blade guard (14).
 Use the switch (20) for activating the machine.