Powerplus POWLI422 LED TORCH 3W + 6W EN - Manual (Page 3)

POWLI422 EN
Copyright © 2014 VARO P a g e | 3 www.varo.com
6 CHARGING THE BATTERY
The work light is using fast charge technology. This light must be
fully charged before being used for the first time. It is recommended
that the battery be re-charged every 3 months to ensure maximum
performance in an emergency.
This will ensure that the battery gives its best performance now and on future re-charging
cycles. The charging base and AC and DC charging adapters are for re-charging the
battery only. They can not be used to directly power the light.
6.1 Using the ac/dc charging adapter

First put the work light into the charging base, the charging position as above picture.
This quick charge work light have magnet on bottom, it can stick the charging base
easily. Then you plug the charging jack into the socket of the charging base next to
the LED charging indicator and make sure it is firmly seated.

Plug the adapter into a 230V socket and switch the socket on (if applicable).
 The charging indicator lamp will glow RED while charging is in progress.
 The battery will be fully charged after approximately 60 minutes, and the RED
charging indicator will turn to GREEN when the unit is fully charged. Disconnect the
jack plug from the charging base, remove the adapter from the wall socket or switch
off.
6.2 Using 12v dc adapter to charge

First put the work light into the charging base, the charging position as above picture.
This quick charge work light have magnet on bottom, it can stick the charging base
easily. Then plug the charging jack into the socket of the charging base next to the
LED charging indicator and make sure it is firmly seated.
 Plug the adapter into the vehicles 12V DC cigarette lighter or accessory power
socket.

The charging indicator lamp will glow RED while charging is in progress.

The battery will be fully charged after approximately 60 minutes, and the RED
charging indicator will turn to GREEN when the unit is fully charged. Disconnect the
jack plug from the charging base; remove the adapter from the 12V socket.
7 TECHNICAL DATA
Model POWLI422
Nominal lifetime 100,000 Hours
Battery
Battery type Li-ion
Battery pack 3.7V-2200mAh
Charging time 1 hour
Top light
Bulb type 3W Cree LED
Working time 3 hours
Side light
Bulb type 12 * 0.5W LED