Powerplus POWLI2352 LED TELESCOPIC 2X20W EN - Manual

POWLI2352 EN
Copyright © 2014 VARO P a g e | 1 www.varo.com
LED LIGHT ON INDUSTRIAL TRIPOD 2X20W
POWLI2352
1 DOMAIN OF USAGE
Outdoor or indoor usage such as jobsite, garden, studio and workshop.
WARNING! Read this manual and general safety instructions
carefully before using the appliance, for your own safety. Your
power tool should only be passed on together with these
instructions.
2 SYMBOLS
In this manual and/or on the machine the following symbols are used:
Read the manual before using the machine
In accordance with essential applicable safety standards of European
directives
3 WARNING

Never attempt to change wire connection way as this has been fixed professionally.
 The lighting fixture shall be fixed on stand vertically that the longitudinal axis does not
slant than ±4°from the ground plate.
 Disconnect the plug (all-poles) from the network when the front glass is open, and
follow the instructions to the next step
 Replace before using the shielding glass if it is damaged.
 If the external flexible cable or cord of this luminary is damaged, it shall be
exclusively replaced by the manufacturer or his service agent or a similar qualified
person in order to avoid a hazard.
4 ASSEMBLING LAMP ON TRIPOD (FIG. 1)

First loosen the wing-nut screw on the tripod (A) and flex the tripod legs. Make sure
the tripod stands stable and retighten the wing-nut.
 Now twist pole screws(B) left to open and extend to your required height. twist right to
lock the pole so it doesn’t slide down.
 Loosen the quick release mechanism(C) and set up the lamp on the top of the pole.
Lock the lamp in place with the quick release mechanism (C).