Powerplus POWAIR0014 PNEUMATIC SANDBLASTING GUN EN - Manual (Page 11)

POWAIR0014 EN
Copyright © 2014 VARO P a g e | 11 www.varo.com
No (or too low)
discharge of blast
media Standpipe or nozzle is
blocked. Clean the respective part as
described.
Compressed air supply is
too weak. Check the settings on the
pressure regulator, make sure
that the maximum working
pressure is not exceeded.
Connect the tool to a stronger
compressed air supply.
Lubricate the tool as described
in the instructions.
Material is wet or
clumped. Use only dry material. Follow the
instructions of the respective
manufacturer.
16 ENVIRONMENT
Should your appliance need replacement after extended use, do not dispose of it with the
household refuse, but in an environmentally safe way.