Edimax Technology BR-6218Mg User Manual

Page 18

Parameter

Description

Obtain an IP address

The ISP requires you to obtain an IP address by DHCP automatically before

connecting to the PPTP server.

Use the following IP

address

The ISP give you a static IP to be used to connect to the PPTP server.

IP Address

This is the IP address that your ISP has given you to establish a PPTP
connection.

Subnet Mask

Enter the Subnet Mask provided by your ISP (e.g. 255.255.255.0)

Gateway

Enter the IP address of the ISP Gateway

PPTP Server

If your LAN has a PPTP gateway, then enter that PPTP gateway IP address
here. If you do not have a PPTP gateway then enter the ISP’s Gateway IP
address above

Enter the User Name provided by your ISP for the PPTP connection.
Sometimes called a Connection ID

Password

Enter the Password provided by your ISP for the PPTP connection

MTU

This is optional. You can specify the maximum size of your transmission packet
to the Internet. Leave it as it is if you to not wish to set a maximum packet size.

Silent Timeout

If specified a non-zero value, gateway disconnects this session after specified
idle time.

Dial On Demand

If checked, gateway won’t dial this session until received a packet that
requested Internet access. If unchecked, gateway dials this session
immediately after system powered up.

Auto Reconnect

If checked, gateway redials this session if session previously terminated by
ISP.

BEZEQ-ISRAEL

Select this item if you are using the service provided by BEZEQ in Israel.

Auth Type

Select PAP or CHAP for the authentication type requested by your ISP.

Click <OK> when you have finished the configuration above. Congratulations! You have completed the
configuration for the PPTP connection. You can start using the router now, if you wish to use some of the
advance features supported by this router see chapter 2, 3, 4.