Casio QV-5700 3 - Manual (Page 46)

REFERENCE
164
Troubleshooting
1. Batteries are not oriented correctly.
2. Batteries are dead.
3. Using the wrong AC adaptor.
1. Activation of Auto Power Off (page 35).
2. Dead batteries
3. You are aligning the Power/function switch with
while the lens cap is attached.
Batteries are low.
1. The power/function switch is aligned with .
2. Flash unit is charging.
3. The message “MEMORY FULL” is on the moni-
tor screen.
4. No memory card loaded in the camera
1. Dirty lens
2. Subject is outside the focus frame.
3. Conditions make it impossible to obtain proper
focus.
4. Camera is unsteady or shaking.
Symptom Probable Cause Action
Power Supply
Recording
No power
Sudden loss of power
indicator on the monitor
screen and Viewfinder
No recording when the
shutter release button is
pressed
Unable to focus properly
with Auto Focus
1. Load batteries correctly (page 29).
2. Replace batteries with a full set of new ones
(page 29).
3. Use only the specified AC adaptor (AD-C620).
1. Turn power back on.
2. Replace batteries with a full set of new ones
(page 29).
3. Remove the lens cap and then turn on power.
Replace batteries with a full set of new ones (page
29).
1. Align the power/function switch with .
2. Wait until flash unit charging is finished.
3. Delete images you no longer need from camera
memory or change to another memory card.
4. Load a memory card.
1. Clean the lens.
2. Compose the image so the subject is inside the
focus frame.
3. Switch to the Manual Focus Mode and focus
manually (page 64).
4. Use a tripod.