Casio EA-200 Technical Reference - Manual (Page 2)

– 2 –
Sampling
1. Channel
Analog
Pulse
Digital I/O
Mic
Analog Output
CH1–3
SONIC
DIG I/O
Mic
CH3 speaker
3
1
1
1
1
Voltage, resistance, pulse period
Channel Name Number of Channels Details
Pulse interval, pulse period
8-bit input/output, 1-bit clock
Recording ( ע1.5V)
CH3: output function
12-bit D/A (
ע3V)
Voltage
Resistance
0–5V
ע10V
1.2mV
4.9mV
Pulse period 0–600sec
Range Resolution Sampling Interval
—
12-bit A/D
Notes
Refer to “Pulse Sampling”
on page 4.
Pulse interval 1–100msec 8msec–16000sec
20 sec–16000sec µ
0.868 sec µ
Fast Mode Normal Extended* 1
Period
Frequency
Fast
Output
Normal
Output
CH1 or
Mic
CH1–3,
SONIC, DIG I
CH1–3,
SONIC, DIG I
CH1 or
SONIC
Speaker
or CH3
CH3 or
DIG O
ࠗ ࠗ ࠗ ן ࠗ ࠗ Communication
Trigger Source
Clock Source
ࠗ ࠗ ࠗ ࠗ ࠗ ࠗ Key Press
ࠗ ࠗ ࠗ ࠗ ן ן Trigger
ࠗ ࠗ ࠗ ן ן ן Countdown
µ
20–
100 sec
0.1msec ןNumber
of Channels to
300sec
300–16000sec —
10msec–
300sec
Timer
ן ࠗ — — — — Communication
ן ࠗ — — — — Key Press
ן ࠗ* 2 — ࠗ ן ן Trigger
ן ࠗ ࠗ ן — —
Communication
while Sampling
Enabled CH
20–
54 sec µ
— 1–100Ω
2. Types of Sampling
3. Sampling Methods
Configuring the Calculator for Sampling
* 1 Warm up is not supported during long-period sampling.
* 2 SONIC sampling triggered by CH1, CH2, or CH3 is not supported.
Auto Setup
When the Setup key is pressed...
Enters the sampling setup ready state.
Supports bundled sensors (temperature, voltage, photo) only.
Auto-ID is read from CH1, CH2, CH3, and SONIC.
(Mic and Digital I/O are not supported.)
Channel Settings When no Auto-ID is available...
CH1, CH2, CH3: Operation=10 (Voltage 1 to 5V)
SONIC: Not used
Sampling Period Furthest Interval among the used Auto-ID is used.
Data Send Priority Non real-time type
Channel Priority: Sampling time, SONIC, CH1, CH2, CH3
* Different from normal. Refer to “Memory” on page 3.