Everpure 2001 - Manual (Page 7)

SUPREMA 2001 - OPERATION & SERVICE MANUAL
Suprema 2001 - Operation & Service July 6, 2001 Page 7 of 60
APPLYING THE FASCIA
7. Apply the fascia to the Suprema front door.
a) Peel the backing paper from the rear of the fascia (Figure 3).
b) Align the fascia inside the plastic trim around the selection panel, making
certain that the fascia does not interfere with the buttons.
c) Once aligned, press the fascia firmly in place (Figure 4).
APPLYING THE INNER DOOR DECALS
8. Apply the "Care and Maintenance" decal.
a) Open the outer door.
b) Peel off the lower half of the backing
paper.
c) Align the upper half of the decal with the
right side of the inner door.
d) When satisfied with the alignment, apply
the lower portion of the decal to the door
surface.
e) Lift the upper portion of the decal and
remove the backing paper.
f) Apply pressure to the upper half of the
decal, from the center outwards.
9. Apply the "Diagram" decal.
a) Peel the backing from the decal.
b) Align the decal below the inner door
grounds deflector.
c) When satisfied with the alignment, apply
pressure to the decal.
! Note:
Do not apply any
pressure to the
fascia until it is
placed in the
proper position.
This way, if it is
not in the right
place, you can
carefully peel it off
and re-position it.
#8
#9
Figure 3 – Remove Backing
Figure 4 – Install Fascia