Everpure 2001 - Manual (Page 58)

SUPREMA 2001 - OPERATION & SERVICE MANUAL
Page 58 of 60 July 6, 2001 Suprema 2001 - Operation & Service
COIN CHANGER INSTALLATION
INSTALLING THE COIN CHANGER
To operate this equipment in “
COIN
” mode, an optional Coinco 9300-series changer
must be installed. This changer can be purchased from your local Coinco retailer.
1. Switch the coffee maker "OFF" and open the inner door.
2. Loosen the three changer mounting screws on the inside of the front door.
a) Using a Phillips screwdriver, loosen (but do not remove) the three
mounting screws.
3. Remove the ‘Acceptor’ unit from the coin changer.
a) Lift the two locking tabs on top of the coin changer.
b) Pull the acceptor towards you. It will pivot, with the base portion
remaining in place.
c) Disconnect the ribbon cable and remove the acceptor.
4. Set the changer to accept and reject certain currencies and denominations
of coins.
a) Locate the DIP switches on the
inside of the coin changer and adjust
them accordingly. Consult the
diagram below for the function of
each switch.
5. Slide the ‘key-hole’ slots of the changer onto the mounting screws.
a) Having removed the acceptor, you
will see three ‘key-hole’ slots on
the rear wall of the changer. Align
these slots with the three mounting
screws on the inside of the door. It
may be necessary to hold the coin
reject assembly (on inside top of
coffee maker) up and out of the
way.
b) Slide the changer down until the
three screws line up with the
narrow part of the ‘key-hole’ slots.
c) Tighten the three screws enough to
secure the changer. Do not over-
tighten.
6. Partially fill the pay-out tubes with an
appropriate amount of coins.
7. Reconnect the ribbon cable and re-install the ‘Acceptor’ unit.
8. Plug the changer into the receptacle on the inside top of the door.
9. Switch the coffee maker "ON".
! Note:
The machine
power MUST be
switched OFF
when
connection or
disconnecting
the coin
changer. Failure
to do so will
damage the coin
changer and the
electronics in
the machine.