Curtis TRCD688 - Manual (Page 8)

Setting the Clock
The clock can be set by using the buttons on the front of the
unit or the remote control.
Setting the Clock using the Unit Controls
1. At STANDBY mode press and hold the PROG/MEM button
for 3 seconds. The display will show either
24H or 12H .
2. Release the PROG/MEM button and use either of the
or buttons to select the clock mode you require, either 12
or 24 hour clock.
3. Press the PROG/MEM button. The display will show the time
with the hours flashing on and off.
4. Use either of the or buttons to select the hour and
press PROG/MEM the hour stops flashing and the minutes
start flashing. Note that for the 12 hour clock mode AM and
PM are displayed.
5. Use either of the or buttons to select the minutes and
press the PROG/ MEM button.
The clock is now set.
Setting the Clock using the Remote Control
1. At STANDBY mode press and hold the PROGRAM/CLOCK
button. The display will change to flash either 24H .
2. Release the PROGRAM/CLOCK button and use the
or buttons to select the clock mode you require.
3. Press the PROGRAM/CLOCK button. The display will show
the time with the hours flashing on and off.
4. Use the or buttons to select the hour and press the
PROGRAM/CLOCK button the hour ceases to flash and the
minutes start flashing.
5. Use the or buttons to select the minutes and press
the PROGRAM/CLOCK button.
The clock is now set.
7