Curtis TRCD688 - Manual (Page 16)

Timer
Setting the timer
1. At STANDBY mode press the TIMER button on the remote
control to turn the timer function on, TIMER will flash for a
short time.
2. While timer is flashing on the display, hold the PROG/MEM
button down for 3 seconds and then release. The display will
show the time with the hours flashing .
3. Use the or buttons to select the hour and press
PROG/MEM. The hour stops flashing and the minutes start
flashing.
4. Use either of the or buttons to select the minutes and
press the PROG/MEM button.
The timer is now set. TIMER will flash for a few seconds then
the display will revert to the previous mode.
Switching the timer off
1. Press the TIMER button to switch the timer off. TIMER will
disappear from the display.
Sleep Function
Your CD micro system can be set to switch off automatically
afer a preset period of between 10 and 90 minutes.
1. While the unit is on , press the SLEEP button on the remote
control. The display will show 90 and SLEEP will flash on and
off. This indicates that the system will switch off in 90 minutes.
2. Successive pressing of the SLEEP button reduces the time
by 10 minutes with each press. For example if you want the
system to switch off in 30 minutes press the SLEEP button
seven times.
3. Afer approximately five seconds the sleep function is
registered. The display reverts to its previous state, SLEEP
stops flashing and remains on .
Note: You have approximately five seconds between successive
pressing of the SLEEP button before the sleep function is
registered.
4. To remove the sleep setting press the SLEEP button again.
SLEEP will be removed from the display.
15