Curtis TRCD688 - Manual (Page 7)

AC Power Connection
1. Connect the mains plug to a mains supply socket and switch
on the supply.
2. At the front of the CD micro system unit, press the POWER
button.
3. The LCD display will light up.
Antenna
The FM antenna is attached to the back of the unit. Unwind the
wire. Positioning is described in the Radio section.
The AM antenna is a separate loop aerial that plugs into the
back of the unit at the socket marked AM ANT. . Its
assembly is described in the Radio section.
Remote Control
1. Open the battery compartment cover.
2. Insert two AAA (Um4) batteries (not included )to match the
polarities as indicated inside the battery compartment.
3. Close the cover.
NOTE: When the batteries become too weak, the operating
distance of the remote controller is greatly reduced and you will
need to replace the batteries.
Operating the remote control
Point the remote control at the front of the CD micro system
to operate. The IR sensor is located below the LCD display.
Do not block the path of the beam from the remote control to
the unit . Dark walls, direct sunlight or very bright light will
reduce the sensitivity of the IR sensor.
6