Curtis TRCD688 - Manual (Page 12)

To Preset Stations using the Unit Controls
1. Press the or buttons to select the desired frequency.
2. Press the PROG/MEM button. MEMORY will flash on the
display.
3. Press the M-UP/REPEAT button until the desired preset
memory number is displayed.
4. Press the PROG/MEM button to store the frequency into the
selected memory location. MEMORY will stop flashing and
remain on the display.
The frequency is now preset.
CD player
Operation
At the front of the CD micro system or using the remote
control, press POWER, to switch the CD micro system on.The
LCD display will light up.
Set the function switch to CD. The display will initially flash
zeros then show no disc .
Only use CDs that bear the CD logo.
Loading and Unloading CDs
1. Press the PUSH OPEN button on the CD door to open the
CD compartment.
Note: If using the CD micro system for the first time, remove
the protective sheet from inside the compartment before use.
2. Remove the CD from its case, place carefully into disc
compartment over the centre spindle and lock in place with the
label side up.
3. Press the OPEN/CLOSE button to close the CD door. The
display will show the total number of tracks.
11