Eaton Electrical 9130 - Manual (Page 14)

Page 14 9130 UPS-EN
4. Operation
This chapter contains information on how to use the Eaton 9130, including front panel operation,
operating modes, UPS startup and shutdown, transferring the UPS between modes, retrieving the
Event Log, setting the power strategy, and configuring bypass settings, load segments, and battery
settings.
4.1 Control Panel Functions
The UPS has a four-button graphical LCD with backlight. It provides useful information about the UPS
itself, load status, events, measurements, and settings (see figure 20).
esc
Figure 20. Eaton 9130 Control Panel.
The button controls only the UPS output. The button has no effect on equipment
connected to the UPS.
Table 3 shows the indicator status and description.
Table 3 - Indicator Descriptions
Indicator Status Description
On The UPS is operating normally on bypass during High Efficiency
operation.
Green Flashing A new information message is active.
On The UPS is in Battery mode.
Yellow Flashing The battery voltage is below the warning level.
On The UPS is in Bypass mode.
Yellow
On The UPS has an active alarm or fault. See "Troubleshooting" on
page 33 for additional information.
Red
Changing the Language
Press and hold the first button on the left for approximately three seconds to select the language menu.
This action is possible from any LCD menu screen.
Display Functions
As the default or after 15 minutes of inactivity, the LCD displays the start screen.
The backlit LCD automatically dims after 15 minutes of inactivity. Press any button to restore the
screen.
Press any button to activate the menu options. Use the two middle buttons ( and ) to scroll through
the menu structure. Press the Enter (
) button to select an option. Press the
ESC
button to cancel or
return to the previous menu.
Power On Indicator (green)
On Battery Indicator (yellow)
Bypass Indicator (yellow)
Alarm Indicator (red)
On/Off Button
Escape Up Down Enter