LW Scientific Dry Bath - Manual (Page 3)

P. 770.270.1394 F. 770.270.2389 865 Marathon Parkway Lawrenceville GA 30046
Operation
3
4
2
1 Insert the desired heat blocks into the recessed area on the top of the dry bath.
Turn on the lighted Power Switch.
Set Temperature: (recommended maximum set temperature not to exceed: 150°C)
Press V or once to display set temp. Display will blink.
Press V or again to increase or decrease set value.
Wait 8 seconds and the new set value will take effect and the display will stop blinking.
To Change from Fahrenheit to Celsius: **Warning – if you are changing from F to C, lower the temperature
setting to 37°C FIRST so the unit doesn’t try to achieve 98.6 C**
Press SET. The display will show “0000.”
Press the > button to select digits, then press the button to change display to program function
“0089.”
Press SET again. The display will show “Inty.”
Press the down arrow V twice until you see “C or F.”
Press SET again. The display will show either “0” or “1.”
Press the button and choose “0” for Celsius or “1” for Fahrenheit.
Press SET again.
Press the button until you see “End.”
Press SET again.
Once you have set the desired temperature, insert your specimen tubes into the chambers in the heat blocks.
Use the provided lift rod or allow blocks to cool before changing or removing from the dry bath.
Never insert any items other than test tubes into the heat blocks. 6
5
C
B
A
D
iii
ii
i
iv
v
vi
vii
viii
ix
V
V
V
V
V