LW Scientific Dry Bath - Manual (Page 2)

P. 770.270.1394 F. 770.270.2389 865 Marathon Parkway Lawrenceville GA 30046 P. 770.270.1394 F. 770.270.2389 865 Marathon Parkway Lawrenceville GA 30046
3
4
2
1
Unpacking & Set Up
Carefully unpack the dry bath incubator and included power adapter, saving packing materials in the unlikely event
you need to return the item. Immediately contact your distributor if you detect any damage. If you need to return
the dry bath to LW Scientific, please use the original packing material.
Place dry bath on a flat, stable surface away from the edges. Ensure that the controls are set in the “OFF” position.
Connect the included power adapter to the dry bath, attach the included line cord, and then plug it into a properly
grounded electrical outlet. (Use only the supplied power adapter and plug.)
Congratulations! You are now ready to use your LW Scientific Dry Bath Incubator.
The dry bath includes 1 lift rod to make it easier to change the blocks.
Caution: As with any temperature controlled equipment, take care not to touch the blocks while the equipment is in
use. Hot surfaces, especially on the block, can cause serious injury or burns.
Do not put water or liquids into the dry bath well.
LW Scientific is not responsible for any injury caused by misuse or abuse of this equipment.
PID Controller
All programming functions of the PID controller have been preset by LW Scientific, and the temperature has been
preset to 98.6°F (37°C). There are many complicated programming functions built into the PID controller, which should
not be altered by the customer. The only two functions that may need to be adjusted by the customer are “Set Tem-
perature” and “Change from Fahrenheit to Celsius” as described below. For any questions about altering other
programming, please contact the LW Scientific technical support department at 800-726-7345 (770-270-1394).
AL- Relay output indicator
Value increment/Select next parameter
Value decrement /Select previous parameter
Auto tuning /Digit shift
Set/Confirm
Will not illuminate
The temperature of the blocks (Process Value, or PV) is displayed during operation. The target temperature (Set
value or SV) is displayed when flashing by pressing the V or key once.
3
4
2
1
7
6
5
V
5