LW Scientific Mi5 - Manual (Page 2)

Unpacking and Setup
Lamp Replacement
Assembly
LW Scientific packs each Mi5 Microscope with utmost care. Examine the
outer and inner containers for any visual damage. Retain all of the packing
material until you have examined and tested your new microscope. If there
is damage, please contact the shipping company, as our warranty does not
cover shipping damage. If you are uncertain who the shipper is, contact the distributor where you purchased the
microscope. Please retain all packaging material for future use. Carefully unpack** your Mi5 Microscope using the
following checklist for all the parts and accessories:
2
4
5
3
1 Remove the body of the microscope and place it on a sturdy, dust-free surface. Remove/unscrew the plastic plugs in
the nosepiece. Install the objectives in such a way that when you turn the nosepiece clockwise, you are moving from
the 4x, to 10x to 20x to 40x and finally to the 100x objective.
Remove the microscope head from the Styrofoam carton and pull off the protective covers from the eyepiece tubes
and head mount. Insert the head mount into the upper arm of the body. Once the head seats, tighten the head
retention screw to secure the head in place. Note: Do not over-tighten.
Remove plastic covers and packing material covering the stage, the condenser and lower light assembly
Insert the 10x eyepieces.
Attach the power cord.
The LED bulb can be replaced by opening the bottom panel (large silver thumb screw). After opening the panel, unclip
the red and black wires by gently squeezing on the sides of the white connecter clip. Using a small screwdriver, remove
both screws on the LED bulb. Remove the bulb. Mount a replacement bulb. Replace and tighten the screws. Reconnect
the electronics by attaching the white connecter clip, and close the bottom panel. Tighten the silver thumb screw to
secure.
Power
If you suspect faulty electronics, call LW Scientific’s technical service department at 800-726-7345.
INPUT: 90-240V / 50-60Hz automatic-switching
1 - Microscope body
2 - 10x eyepieces
5 - Objectives 4X, 10X, 20X, 40XR,
100XR (oil)
1 - Power cord
1 - Immersion oil
1 - Dust cover
1 - Abbe condenser
2 - Rubber eye guards
2 - Fuses (2 Amp)
Box 1: Box 2: Box 3:
1 - Binocular head (Seidentopf style),
optional Trinocular head