Lanner FW-8759 - Manual (Page 9)

3
Introduction
Network Application Platforms
Chapter 1
Front Panel Features
F1, F10 Power/Status/HDD LED
Power: If the LED is on it indicates that the system is powered on. If it is off, it indicates that the system is powered off.
Status: This LED is programmable. You could program it to display the operating status with the following behavior:
If the LED is green, it indicates that the system’s operational state is normal. If it is red, it indicates that the system is
malfunctioning.
HDD: If the LED blinks, it indicates data access activities; otherwise, it remains off.
F2 LCD System Panel with keypad
The LCD System Panel can be programmed to display operating status and configuration information. For more details or
sample programming code, please refer to the Drivers and user’s manual CD.
F3 Reset Switch
The reset switch can be used to reboot the system without turning off the power.
F4 Console Port
By using suitable rollover cable or RJ-45 to DB-9 console cable, you can connect to a computer terminal for diagnostic or
configuration purpose. Terminal Configuration Parameters: 115200 baud, 8 data bits, no parity, 1 stop bit , no flow control.
The terminal parameters can be altered in the BIOS menu, go to BIOS -> Advanced -> Serial Port Console Redirection ->
COM0->select enabled first and then go to ->Console Redirection Settings > [115200, 8 , n ,1 ]
F5 Two USB 2.0 Ports
F6 Ethernet Ports (LAN1-LAN2: bypass pair, LAN3-LAN4: bypass pair; LAN5-LAN6: bypass pair)
LINK/ACT (Yellow)
On/Flashing: The port is linking and active in data transmission. •
Off: The port is not linking. •
SPEED (Green/Amber)
Amber: The connection speed is 1000Mbps. •
Green: The connection speed is 100Mbps •
Off: The connection speed is 10Mbps. •
They are provided by Intel i210. Moreover, 3pairs (LAN1-LAN2, LAN3-LAN4, LAN5-LAN6) can be configured as LAN bypass
(Lanner Generation 3) when failure events occur. This feature can be enabled dynamically with a watch dog timer. Refer to
your User’s Manual CD for a sample implementation of this feature.
F1 F2 F3 F4
F6
LAN1 LAN2 LAN3 LAN4 LAN5 LAN6 LAN7 LAN8
(bypassed pair) (bypassed pair) (bypassed pair)
F7 F8
F10
F5
F9