Lanner FW-5330 - Manual (Page 9)

6
Hardware Setup
Chapter 2
Network Application Platforms
Installing the CompactFlash Card
FW-5330 provides one CompactFlash slot slot. Follow the
procedures below to install a CompactFlash card.
Align CompactFlash card and the card slot with the 1.
arrow pointing toward the connector.
Push the card to insert into the connector.
2.
Installing the Hard Disk
FW-5330 provides one SATA disk installation. Follow these
procedures bellow to install a SATA disk:
Unscrew the 4 screws on the hard disk tray to take out 1.
the hard disk tray from the system.
Place hard disk on the hard disk tray and align the holes
2.
of the hard disk with the mounting holes on the tray.
Secure the hard disk with 4 mounting screws on the
3.
hard disk tray.
Connect the Serial-ATA cable to the hard disk.
4.
Plug the Serial-ATA power and data cable to the Serial- 5.
ATA connectors on the main board.
Put the hard disk tray with the installed hard disk back
6.
to the system and secure it with the mounting screws.
Note:
The hard disk tray sits under the chassis rim and not
above it so that the cover can be closed perfectly
without any gap.
sits under the chassis rim