Rear panel features, Chapter 1, Introduction – Lanner FW-5330 User Manual
Page 7

4
Introduction
Chapter 1
Network Application Platforms
Rear Panel Features
R1
R1 Reset Switch
A hardware or a software reset switch. To use it as a software reset, refer to sample code (DOS) in the Driver and User
Manual CD.
R2 DC-12V 3A
DC-in connector for connecting DC power source (36W). Use only the power adaptor included within the package.
R3 ATX Power Switch
A system power switch.
R4 Console Port
It is a console port via RJ45 connector. Using suitable console cable, you can connect an appropriate device, for example,
a terminal console for diagnostics.
Default Terminal Configuration Parameters: 115200 baud, 8 data bits, no parity, 1 stop bit , no flow control. These
parameters can be changed in the BIOS menu, see Console Redirection in Chapter 4 BIOS Settings.
R5 USB 2.0 Ports
It connects to any USB devices, for example, a flash drive. Besides this external USB port, there is another one with the
internal pin headers (refer to Jumper Setting on Chapter 3 Motherboard Information)
R6 4 Ethernet 10/100/1000 Mbps Ports
There ports are provided by Realtek RTL 8111E.
R6
R2
R3
R4
R5