Lanner FW-5330 - Manual (Page 8)

5
Hardware Setup
Chapter 2
Network Application Platforms
Chapter 2:
Hardware Setup
Preparing the Hardware Installation
To access some components and perform certain service
procedures, you must perform the following procedures
first.
WARNING: To reduce the risk of personal injury,
electric shock, or damage to the equipment,
remove the power cord to remove power from the
server. The front panel Power On/Standby button
(if there is one) does not completely shut off
system power. Portions of the power supply and
some internal circuitry remain active until power
supply is removed.
Unpower the FW-5330 and remove the power cord. 1.
Unscrew 2 screws from the two sides of the top cover 2.
of the FW-5330 System.
Slide the cover backwards to open it. 3.
Installing the System Memory
The motherboard supports DDR3 memory to meet the
higher bandwidth requirements of the latest operating
system and Internet applications. It comes with one
Double-Data-Rate Three (DDR3) Small Outline Dual Inline
Memory Modules (SO-DIMM) socket.
Align the SO-DIMM connector key with the socket key,
and then install the DIMM firmly into the socket.
Note:
SO-DIMM installed must meet the following 1.
requirement: unbuffered, non-ECC DDR3
memory.
The motherboards can support a total memory 2.
capacity of 4 GB in maximum.
Notch
1
2