Empire Comfort Systems VFHS-20/10T-4 - Manual (Page 10)

Page 10 16717-2-0605
INSTALLATION OF FIREPLACE INTO MANTEL
Installing Fireplace in Mantel ( Figure 9)
Figure 9
1. Position base approximately 5" from wall surface.
2. Attach nailing flange to fireplace top with two (2) 10 x 1/2"
screws.
3. Place fireplace on top of base.
4. Gas line connections must be made at this time. When facing
the fireplace the gas supply will enter on right-hand side. See
"Gas Supply" Page 8.
5. Place right mantel side against base. Insert dowels in
breastboard into right mantel side. Breastboard will rest on
fireplace top and in front of nailing flange.
Attention: Placing the breastboard in front of nailing flange
will secure the fireplace.
6. Place left mantel side against base. Insert dowels in breastboard
into left mantel side.
7. Use four (4) pre-drilled screw holes on back of breastboard
to secure breastboard to mantel sides with four (4) Philips
wood screws.
8. Place mantel top onto mantel.
9. Installation of fireplace into mantel is completed.
Installation of Brass Trim
1. Lower bottom louver.
2. Remove screen from fireplace.
3. Remove top louver from fireplace [two (2) Phillips screws].
4. Attach right and left brass trim, sides to fireplace. Use two (2)
Phillips screws for each side.
5. Attach brass trim top to fireplace with two (2) Phillips
screws.
Figure 8