Yaskawa E7 Apogee FLN - Manual (Page 50)

Troubleshooting A-6
! Speed Command Operation Parameter Is Set Correctly
The speed command operation parameter needs to be set for “Serial Com”.
Table A.2 - Speed Command Operation Parameter
Parameter Number Setting Choices Setting Descriptions
0 Operator
1 Terminals
2
Serial Com (APOGEE FLN)
b1-01
3 Option PCB
Correct and Unique Network Address
Each device on an APOGEE FLN network requires its own unique address. The drive also needs to be programmed to accept the APOGEE
FLN protocol.
Table A.3 - Serial Communication Device Address Parameter
Parameter Number Setting Range Setting Description
H5-01 0 to 63 hex Serial communication device address
H5-08 0 to 2 2: FLN (APOGEE)