Line up tabs – Yaskawa BACnet MS/TP SI-B3/V User Manual

Page 27

Text mode
Original mode

network line, enable the termination resistor by setting DIP switch S1 to the ON
position. Disable the termination resistor on all slaves that are not located at the end
of the network line by setting DIP switch S1 to the OFF position (The factory setting
for DIP switch S1 is OFF).

15.

Attach the option cover by aligning the tabs with the mounting holes, seat the front
cover into place, and tighten the screw on the front.

Line up tabs

Figure 20 Attach the Option Cover

Note:

Take proper precautions when wiring the option so that the front covers will easily fit back onto

the drive. Make sure no cables are pinched between the front covers and the drive when

replacing the covers.

16.

Set drive parameters in

Table 7

for proper option performance.

5 Installation Procedure

YASKAWA TOEP YAICOM 19A V1000 Option BACnet MS/TP SI-B3/V Installation & Technical Manual